26
To manually test the standby battery, push the
key, enter the digit "6", the digit "4", then push the
# key.
STANDBY BATTERY TEST
Your alarm system can be programmed to automatically test its standby
battery every 24 hours. During the test, AC power is turned off in order to
monitor the battery under load.
OPTION
INSTALLED
.
46
.
The standby battery test takes 2 minutes. During the test, the POWER light will be off.
If the battery is okay, the keypad will beep twice.
If the battery is low or dead, the POWER light will flash, and the keypad will beep five
times.
.
BELL/SIREN TEST
To test the bells/sirens in your security system:
Enter your PIN (if required), push the key, enter the digit "6", the digit "3",
then push the # key.
36
The bell/siren and keypads will sound for 3 seconds.
.
OPTION
INSTALLED
PIN
REQUIRED
To Next Page
Loading...
