15
ZONE #
ZONE #
.
To bypass more than one zone: enter your
PIN (if required), push the key, enter the
first zone to be bypassed, push the
key again, enter the next zone to be bypassed,
and so on. When the last zone to be bypassed
has been entered, push the # key.
.
To indicate that zones are bypassed, the display will read BYPASSED ZONE. To see
which zones are bypassed, push the # key (once for each bypassed zone).
.
The procedures for adding a bypass and removing a bypass are identical. To
remove a bypass: enter your PIN, push the key, enter the zone from which the
bypass is to be removed, then push the # key.
When you have finished bypassing zones, arm the system by entering your PIN and
pushing the # key.
.
NOTE: Disarming your alarm system REMOVES all bypasses.
PIN
REQUIRED
#
System: 238, 238i, 2316, 2316i ONLY
To Next Page
Loading...
