20
TO DISARM THE SYSTEM:
Enter only through a TIME DELAY door.
.
OPTION
INSTALLED
The display will read ENTRY - DISARM NOW. A bar graph will appear on the display,
showing how much entry time remains.
Enter your PIN within
seconds and push the # key.
PIN
REQUIRED
Make sure the red ARM light on the keypad goes off.
If the ARM light does not go off, wait for the keypad to beep five times, then enter your
PIN again.
.
The display will read READY TO ARM or NOT READY TO ARM (if a zone is faulted).
.
If the ENTRY PRE-ALARM option is installed, the keypad will sound constantly until 10
seconds before the delay time expires (or the panel is disarmed), then beep rapidly for
the last 10 seconds.
.
#
To Next Page
Loading...
