Need help?Do you have a question about the C&K systems System 236 and is the answer not in the manual?
Defines the components of the alarm system, including control panel and detection devices.
Explains the process when a detection device is triggered, including alarm conditions and central station notification.
Enables automatic bypass of interior zones when arming, keeping perimeter zones armed.
Converts all time delayed zones to INSTANT zones, making them active upon arming.
Arms perimeter zones while bypassing interior zones, allowing movement within the premises.
Arms perimeter zones and bypasses interior zones, converting entry delays to INSTANT.
Allows bypassing of one or more zones while the system is disarmed for specific systems.
Procedure to bypass zones for System 236 and 236i.
Prevents system arming if any non-24-hour zone is faulted.
Automatically bypasses violated zones during exit delay until system disarming.
System arms with faulted zones; bell/siren chirps for entry delay if EXIT DELAY zone remains faulted.
Eliminates exit delay when using specific arming modes.
Transmits alarm signals to the central station when installed.
Holding the EMERGENCY key for three seconds triggers an alarm.
Holding the FIRE key for three seconds triggers an alarm.
Holding the POLICE key for three seconds triggers an alarm.
Allows sending a silent DURESS signal by modifying the last digit of the PIN.
Send a silent DURESS signal using User Code 6 for system 236i.
Send a silent DURESS signal using User Code 7 for systems 238i and 2316i.
Allows programming a GUEST COMBINATION valid for a specified number of days.
Bell/siren sounds for two seconds after system arming.
Procedure for User 1 to change PINs for Users 1-8 using their Master PIN.
Procedure for User 1 to delete PINs for Users 2-8 using their Master PIN.
Procedure for User 1 to change PINs for Users 1-6 or 1-32.
Procedure for User 1 to delete PINs for Users 2-6 or 2-32.
Procedure to reset smoke detectors after they have been triggered.
All keypads beep for two seconds when a designated zone is faulted.
System switches to standby battery during AC power loss.
Allows on-site testing of each zone in the system.
Tests the system's standby battery by turning AC power off to monitor performance.
Tests the bells/sirens in the security system.
Tests the reporting capability by sending a test message to the central station.
Steps to diagnose and resolve telephone line issues with the alarm system.
Control the backlight of ALPHA Plus keypads by pressing a specific key combination.
Enable or disable audible feedback on keypads using a specific key combination.
Toggle entry and exit delay warning tones on or off using a specific key combination.
Turn door chime tones on or off at each keypad using a specific key combination.
Recommended placement of detectors in sleeping areas for optimal detection.
Guidance on detector placement relative to bedrooms and other house areas.
Specific placement advice for detectors near stairwells.
Steps to plan and prepare for emergencies, including escape routes and meeting points.
Safety measures to take during an emergency evacuation, such as checking doors and moving through smoke.
A condition that occurs when detection devices are triggered after the system is armed.
To take a zone out of the circuit, allowing the rest of the system to be armed.
Time to enter premises and disarm panel before an alarm occurs.
Time to exit premises through a DELAY DOOR after the system is armed.
Combination used to arm/disarm the control panel and access functions.
One of the protected areas in your premises.
Discusses the inherent limitations and potential failure points of alarm systems.
Weekly test for on-site testing of each zone in the system.
Weekly test to verify transmission of signals to the central station.
Weekly test for bells/sirens in the security system.
Weekly test to check the standby battery performance.
Compliance with FCC limits for Class B digital devices and RF energy.
Compliance with FCC rules for equipment connected to the telephone network.
General| Brand | C&K systems |
|---|---|
| Model | System 236 |
| Category | Keypad |
| Language | English |
To Next Page
