C&K systems System 236 - CHANGING A USER PIN - SYSTEM 238 and 238 i

26
User 1 can use his Master PIN to change the PINs of Users 1 - 8.
CHANGING A USER PIN - SYSTEM 238 and 238i
Enter your Master PIN, push
the key, enter the digit "0", then
push the # key.
0
MASTER PIN
REQUIRED
The display will read PROGRAMMING.
Enter the new PIN and push
the # key.
The new PIN can be from two to five digits long, but must start with
the same first digit as the old PIN.
.
Enter the new PIN again and
push the # key.
.
#
*
#
#
*
If the new PIN is accepted, the keypad will beep twice, and the display will read PIN
ACCEPTED. If you make a mistake while programming, or if the system rejects the new
PIN, the keypad will beep five times, and the display will read INVALID PIN.
System: 238 and 238i ONLY