17
.
To indicate that zones are bypassed, the display will read BYPASSED ZONE. To see
which zones are bypassed, push the # key.
The procedures for adding a bypass and removing a bypass are identical.
To remove a bypass:
.
.
NOTE: Zones can also be bypassed by remote programming. The system can either be
armed or disarmed for remote programming.
1
Enter your PIN, push the key, enter the digit "2", enter the zone
from which the bypass is to be removed, then push the # key.
OR
NOTE: Disarming your alarm system REMOVES all bypasses.
Enter your PIN, push the key, enter the zone from which the
bypass is to be removed then press the # key.
*
System: 236 and 236i ONLY
To Next Page
Loading...
