C&K systems System 236i - Testing Your System; Local System Test

35
LOCAL SYSTEM TEST
This option allows on-site testing of each zone in your system.
To initiate the SYSTEM TEST:
Enter your PIN (if required),
push the key, enter the digit "6",
the digit "0", then push the # key.
The display will read WALK TEST. Walk through the
areas protected by motion sensors; open and close
protected doors and windows. Each time a zone is faulted, the display
will show the faulted zone's identification, and the keypad will chime.
PIN
REQUIRED
6 0
.
WARNING: Your alarm system will not report alarms during the LOCAL SYSTEM TEST.
*
#
*
☞
To exit the system test, push any key. The display will momentarily read
SYSTEM RESET.
.