13
BULB REPLACEMENT
Important :
The bulb must be replaced by the manufacturer, its
service agent or similarly qualified persons.
Always switch off the electricity supply before
carrying out any operations on the appliance. When
handling bulb, make sure it has completely cooled
down before any direct contact to hands.
When handling blubs hold with a cloth or gloves to
ensure perspiration does not come in contact with
the blub as this can reduce the life of the blub.
Note:
Before changing the lights that the cooker hood can be isolated from the supply
mains by means of a plug or an all-pole switch.
Protect against danger when changing lights, such as wearing gloves.
Changing the light
Switch off the appliance and make sure it’s disconnected from the mains supply.
You should use a suitable screwdriver to pry up one end of the light and take it out
for replacement.
ILCOS D code for this lamp is: DBS-2/65-H-120/33
– LED modules –rectangle LED lamp
– Max wattage: 1×2 W
– Voltage range: AC 110-240V
– Dimensions:
To Next Page
Loading...
Need help?
General
