Why Candy Washer does not work / start?
If your Candy Washer doesn't start, try these steps: * Ensure the washer is plugged into a working socket and the power is on. * Test the wall socket with another appliance. * Open and close the door again to ensure it's correctly closed. * Check that you've correctly selected the program and pressed the start button. * Make sure the washer isn't in pause or time delay mode.
What to do if my Candy Washer has water leaked on the floor?
If you notice water leaking near your Candy Washer, it could be due to a leak from the seal between the tap, supply hose, and fill valve. In this case, replace the seal and tighten the hose connections properly. Also, make sure the front filter is correctly closed.
Why Candy CBW27D1E-S Washer does not spin?
If your Candy Washer isn't spinning, try these steps: 1. Remove and de-tangle the load, then reload it and restart the spin program. 2. Wait a few minutes. 3. Ensure the 'no spin' function is not selected (if your model has one). 4. Check the selected options and their effect on the spin cycle. 5. Make sure you're using the correct amount of detergent, as excessive detergent can impede the spin cycle.
What to do if Candy CBW27D1E-S Washer makes strong vibrations / noises during the spin cycle?
If your Candy Washer is vibrating strongly or making unusual noises during the spin cycle: * Adjust the feet as indicated in the specific section, if necessary. * Ensure that the transport screws, rubber bungs, and spacer tubes have been removed. * Check the drum for any foreign objects like coins, hinges, or buttons.
What to do if Candy CBW27D1E-S displays E2 error?
If your Candy Washer displays error code E2 or the LEDs flash twice, ensure that: * The water supply tap is open. * The water supply hose isn’t bent, kinked, or trapped. * The drain pipe is at the proper height (see installation section). * The “anti-sand” filter is clean and not blocked (close the water supply tap, unscrew the filler hose from the back of the washing machine to check it). * The filter is not clogged and there are no foreign bodies inside the filter compartment.
What to do if Candy CBW27D1E-S displays E3 error?
If your Candy Washer displays error code E3 or the LEDs flash three times, check that: * The filter is not clogged and there are no foreign objects inside the filter compartment. * The drain hose isn’t bent, kinked, or trapped. * The home drainage system is not blocked and is allowing water to flow through without obstruction. Try to drain the water in the sink.
What to do if Candy CBW27D1E-S displays E7 error?
If your Candy Washer displays error code E7 or the LEDs flash seven times: * Make sure the door is correctly closed and that clothes inside the drum are not preventing it from closing fully. * If the door is locked, turn off and unplug the washing machine, wait 2-3 minutes, and reopen the door.
What to do if Candy Washer displays E4 error?
If your Candy Washer displays error code E4 or the LEDs flash four times, ensure that the correct amount of detergent is being used and that the detergent is designed for use in a washing machine.
Defines appliance usage scenarios and user limitations.
Guidelines for safe operation around children.
Requirements for electrical system, cords, and sockets.
Precautions during cleaning, moving, and in case of faults.
Instructions for removing transit screws and securing parts.
Attaching the appliance's door to custom furniture.
Sliding the unit into place and adjusting feet for stability.
Final positioning, levelling, and plugging into the electrical outlet.
How to connect the water inlet hose.
Description of Hot&Cold, Aquastop, and Aquaprotect systems.
Explains which compartment is for what.
Warnings about liquid products and direct drum dispensing.
Advice on preparing clothes for washing.
Ways to reduce consumption.
When to use pre-wash and hot temperatures.
Guidance on selecting and using detergents for various conditions.
Cleaning the outside cabinet and detergent drawer.
Cleaning the filter to prevent blockages.
Instructions for periods of disuse or relocation.
Step-by-step guide to starting a wash cycle.
Summary of water pressure, spin speed, and power info.
Identifies all buttons and display elements.
Steps for starting, pausing, cancelling, and door opening.
How to schedule a wash start.
Details on Extra Rinse, Hygiene+, Easy Iron.
Using Rapid and Stain Level buttons.
Adjusting wash temperature and spin speed.
Locking controls and modifying spin speed.
Understanding the display and core indicator lights.
Detailed explanation of Kg Detector, Key Lock, Temp, and Spin Speed indicators.
Notes on temperature, duration, and rapid programs.
Tips for new garments and colourfastness.
Descriptions for Shirts to Hygiene programs.
Descriptions for Wool/Hand Wash to Perfect Cotton 59' programs.
How error codes are displayed.
Solutions for errors E2, E3, E4, E7.
Solutions for non-starting, leaks, no spin, and noise.
Terms and conditions of the guarantee.
How to obtain help.
CE mark compliance and manufacturer notes.
General| Type | Front Load |
|---|---|
| Loading type | Front Loading |
| Capacity | 7 kg |
| Spin Speed | 1200 rpm |
| Energy Efficiency Class | A+++ |
| Weight | 62 kg |
| Color | White |
| Dimensions (HxWxD) | 850 x 600 x 540 mm |
| Water Consumption | 44 L |
To Next Page
