Candy CDH30 - Connecting the Hob to the Mains Power Supply

t
emperature will not exceed 75˚C at any point.
Th
e power supply should be connected in compliance with the relevant standard or a single-pole circuit breaker. the
method of connection is shown below.
1
. If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper tools, so
as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a
minimum gap of 3mm between the contacts.
3. The installer must ensure that the correct electrical connection has been made and that it complies with safety
regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a properly qualified person.
D
ISPOSAL: Do not
di
spose this product
as
unsorted municipal
w
aste. Collection of
s
uch waste separately
f
or special treatment is
ne
cessary.
T
his appliance is labeled in compliance with European
d
irective
20
2/ /EC for Waste Electrical and Electronic
Equ
ipment (WEEE).
B
y ensuring that this appliance is
d
isposed of correctly, you will help
p
revent any possible
d
amage to the environment and to h
uma
n
he
alth, which
m
ight otherwise be caused if it were disposed of in the
1
19
w
rong way.
T
he symbol on the product indicates that it may not be
tr
eated as
norm
al household waste. It should be taken to a
co
llection point for
th
e recycling of electrical and el
e
ctronic
g
oods.
T
his appliance requires specialist waste disposal. For
f
urther
i
nformation regarding the treatment, recover and
r
ecycling of this
p
roduct please contact your local council,
y
our household waste
d
isposal service, or the shop where
y
ou purchased it.
F
or more detailed information about treatment, recovery
an
d
re
cycling of this product, please contact your local city
o
ffice, your
hous
ehold waste disposal service or the shop
w
here you purchased
th
e product.
C
onnecting the hob to the mains power supply
Th
is hob must be connected to the mains power supply only by a suitably qualified person.
Before connecting the hob to the mains power supply, check that:
1. the domestic wiring system is suitable for the power drawn by the hob.
2. the voltage corresponds to the value given in the rating plate
3. the power supply cable sections can withstand the load specified on the rating plate.
To connect the hob to the mains power supply, do not use adapters, reducers, or branching
devices, as they can cause overheating and fire.
The power supply cable must not touch any hot parts and must be positioned so that its
EN-13
220-240V~
Valid only for Cyprus