Candy CF 3E9L0W-80 - Common Faults and Solutions

39
EN
ERROR E21 (with
display)
with a short
audio signal
Uncontrolled water supply with open solenoid valve.
Close the water tap immediately and disconnect the appliance from
the power supply.
Any other code
(with display)
Turn off and unplug the dishwasher, wait a minute. Turn on the
machine and restart a program. If the error occurs again contact an
Authorised Customer Service Centre directly.
If malfunctions or faults occur when a programme is running, the indicator light that
corresponds to the selected cycle will blink rapidly, and an intermittent audio signal will
sound. In this case, turn the dishwasher off by pressing the "ON/OFF" button.
After checking to make sure the water supply is open, that the drain pipe is not bent
and that the siphon or filters are not clogged, set the selected program again.
If the fault persists, contact the Technical Assistance Centre.
FAULTS
CAUSE
SOLUTION
1. No programme
works
Plug not connected to wall socket
Connect electric plug
O/I button not pressed
Press button
Door is open
Close door
No electricity
Check
2. Dishwasher
does not fill
with water
See point 1
Check
The water tap is closed
Open the water tap
The water supply hose is bent
Eliminate the bends in the hose
The filter of the water supply
hose is clogged
Clean the filter at the end of the
hose
Other faults
WARNING
To ensure the correct operation of the overflow safety device, we
recommend not moving or tilting the dishwasher during operation.
Should it be necessary to tilt or move the dishwasher, please
ensure that the washing cycle is complete and that no water
remains inside the appliance.
This dishwasher is equipped with an overflow safety device that, in the event of a
problem, automatically discharges any excess water.
Only models without a display