Using your Induction Hob
To start cooking
• After power on, the buzzer beeps once, all the indicators light up for 1 second then
go out, indicating that the hob has entered the state of standby mode.
1. Touch the ON/OFF switch. all the indicators show “– “
2. Place a suitable pan on the cooking zone that you wish to use.
Make sure the bottom of the pan and the surface of the
cooking zone is clean and dry.
3. Select a heat setting by touching the “slider” control.
• If you don’t choose a heat setting within 1 minute,
the Induction hob will automatically switch off.
You will need to start again at step 1.
• You can modify the heat setting at any time during
cooking.
When you have finished cooking
1. Turn the cooking zone off by touching “slider”control
down to“0”. Make sure the display shows“0”.
2. Turn the whole hob off by touching the ON/OFF
control.
3. Beware of hot surfaces
“H” will show which means cooking zone is too hot to touch. It
will disappear when the surface has cooled down to a safe
temperature. It can also be used as an energy saving function if
you want to heat further pans, use the hotplate that is still hot.
To Next Page
Loading...
