Using your Induction Hob
To start cooking
• After power on, the buzzer beeps once, all the indicators light up for 1 second then
go out, indicating that the hob has entered the state of standby mode.
1. Touch the ON/OFF switch. all the indicators
show “– “
2. Place a suitable pan on the cooking zone that you
wish to use.
Make sure the bottom of the pan and the surface of
the cooking zone are clean and dry.
3. Touching the heating zone selection control, and an
indicator next to the key will flash
4. Select a heat setting by touching the “slider” control.
• If you don’t choose a heat setting within 1 minute,
the Induction hob will automatically switch off.
You will need to start again at step 1.
• You can modify the heat setting at any time during
cooking.
When you have finished cooking
1. Touching the heating zone selection that you wish to
switch off
2. Turn the cooking zone off by touching “slider”control
down to“0”. Make sure the display shows“0”.
3. Turn the whole cooktop off by touching the ON/OFF
control.
To Next Page
Loading...
