20
EN
Use the 4 feet to level the
machine with the floor:
a) Turn the nut clockwise to
release the screw adjuster of
the foot.
b) Rotate foot to raise or
lower it until it stands firmly on
the ground.
c) Lock the foot in position
by turning the nut anti-
clockwise until it comes up
against the bottom of the
machine.
Ensure that the knob is on
the “OFF” position and the
load door is closed
Insert the plug.
ATTENTION:
should it be necessary to
replace the supply cord,
connect the wire in
accordance with the
following colours/codes:
BLUE - NEUTRAL (N)
BROWN - LIVE (L)
YELLOW-GREEN - EARTH ( )
After installation, the
appliance must be
positioned so that the plug is
accessible.
SL
Uporabite vse 4 nogice,
zravnate pralni stroj z tlemi
a) Matico, s katero je pritrjena
nogica sprostite tako, da jo
odvijete z
ustreznim kljuãem.
b) Nogico z obraãanjem
zvi‰ujte ali zniÏujte toliko ãasa,
dokler se ne bo povsem
prilegala tlom.
c) Po konãanem izravnavanju
nogico ponovno pritrdite tako,
da jo z ustreznim kljuãem
privijate v smeri nasprotni od
gibanja urinih kazalcev dokler
se povsem ne prileÏe dnu
stroja.
Prepriãajte se, da je gumb
programatorja v izklopljenem
poloÏaju in da so vrata stroja
zaprta.
Vtaknite vtiã v vtiãnico.
POZOR:
ãe je treba zamenjati prikljuãni
elektriãni kabel, prikljuãite Ïice
skladno s spodaj navedenimi
barvami/kodami:
MODRA - NULA (N)
RJAVA - FAZA (L)
RUMENA-ZELENA - OZEMLJITEV ( )
Stroj mora biti name‰ãen tako,
da lahko vtiãnico doseÏete v
vsakem trenutku.
To Next Page
Loading...
