EasyManuals Logo

Candy CS2 108 User Manual

Candy CS2 108
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #33 background imageLoading...
Page #33 background image
33
ВЫБОР ПРОГРАММ
Обратитесь к таблице выбора про-
грамм, чтобы выбрать наиболее под-
ходящую для Вас программу.
Поворотом ручки селектора про-
грамм активируется выбранная про-
грамма.
Дождитесь, пока не начнет мерцать
индикатор "STOP", после этого на-
жмите кнопку "СТАРТ/ПАУЗА".
При нажатии кнопки "СТАРТ/ПАУЗА"
машина запускает рабочую последо-
вательность.
Программа выполняется при неиз-
менном положении селектора про-
грамм до завершения цикла.
ВНИМАНИЕ!
Даже при сбое в электросе-
ти во время работы маши-
ны, специальное устройст-
во памяти запоминает вы-
бранную программу и мо-
мент ее прерывания. При
восстановлении электропи-
тания машина продолжает
работу с момента останов-
ки.
- По окончании программы загора-
ется индикатор "Конец цикла" ("End
cycle").
- По окончании стирки подождите
около 2 минут, пока не откроется уст-
ройство блокировки люка.
- Выключите машину поворотом ру-
коятки выбора программ в положение
"Выкл." (Off).
- Откройте люк и достаньте белье.
Перед любой стиркой обрати-
тесь к таблице программ стир-
ки, и соблюдайте последова-
тельность операций, рекомен-
дованную этой таблицей.
PROGRAMME SELECTION
Refer to the program guide to select the
most suitable program.
Turning the selector knob required pro-
gram is activate.
Wait for the "STOP" indicator light to
flash. Then press the "START/PAUSE"
button.
When the "START/PAUSE" button is
pressed the machine sets the working
sequence in motion.
The program carries out with the pro-
gram selector stationary on the selected
program till cycle ends.
WARNING!
If there is any break in the
power supply while the ma-
chine is operating, a special
memory stores the selected
program and, when the power
is restored, it continues
where it left off.
- At the end of the program the indica-
tor light "End cycle" will go on.
- When the program has finished wait
for the door lock to be released (about 2
minutes after the program has finished).
- Switch off the machine by turning the
program selector to the "OFF" position.
- Open the door and remove the laun-
dry.
For all types of wash consult the
program table and follow the op-
erations in the order indicated.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Candy CS2 108 and is the answer not in the manual?

Candy CS2 108 Specifications

General IconGeneral
BrandCandy
ModelCS2 108
CategoryWasher
LanguageEnglish

Related product manuals