How to fix water leak from Candy Washer?
If you see water leaking near your Candy Washer, it might be coming from the seal between the tap, supply hose, and fill valve. Try replacing the seal and tightening the hose connections correctly. Also, ensure that the front filter is correctly closed.
Why Candy CS 1410TXME/1-S Washer does not spin?
If your Candy Washer isn't spinning, try these steps: remove the load, detangle it, reload it, and restart the spin program. If water hasn't completely drained, wait a few minutes, or refer to the Error 3 section. Ensure the "no spin" function isn't selected. Also, check the selected options and their impact on the spin cycle. Excessive detergent can also impede spinning, so ensure you're using the correct amount.
Why Candy CS 1410TXME/1-S Washer does not work?
If your Candy Washer doesn't start, ensure it's properly plugged into a working socket and that the power is on. Check the wall socket with another appliance. Also, make sure the door is correctly closed, the program is correctly selected, the start button has been pressed, and that the machine isn't in pause or time delay mode.
What to do if Candy CS 1410TXME/1-S Washer shows E2 error?
If your Candy Washer displays error code E2 or the LEDs flash twice, it indicates the machine cannot load water. First, ensure the water supply tap is fully open. Then, check that the water supply hose isn’t bent, kinked, or trapped. Also, make sure the drain pipe is at the proper height as shown in the installation section. Close the water supply tap and inspect the “anti-sand” filter in the filler hose for blockages. Finally, check the filter for clogs or foreign objects that may be obstructing water flow.
What to do if Candy CS 1410TXME/1-S shows E3 error?
If your Candy Washer displays error code E3 or the LEDs flash three times, it means the washing machine isn't draining water. Check the filter for clogs or any foreign objects. Ensure the drain hose isn’t bent, kinked, or trapped. Also, verify that your home drainage system isn't blocked by trying to drain water into the sink.
What to do if Candy Washer shows E7 error?
If your Candy Washer displays error code E7 or the LEDs flash seven times, there may be a door issue. Ensure the door is correctly closed and that clothes inside aren't preventing it from closing fully. If the door is locked, turn off and unplug the washing machine, wait 2-3 minutes, and then reopen the door.
Why Candy Washer vibrates so much?
If your Candy Washer is vibrating strongly or making a lot of noise during the spin cycle, it might not be fully leveled. Adjust the feet as shown in the manual. Also, ensure that the transport screws, rubber bungs, and spacer tubes were removed during installation. Finally, check the drum for any foreign objects like coins or buttons.
What to do if Candy CS 1410TXME/1-S shows E4 error?
If your Candy Washer displays error code E4 or the LEDs flash four times, it indicates there is too much foam or water. Make sure you are using the correct amount of detergent and that the detergent is designed for use in a washing machine.
General| Load Capacity | 10 kg |
|---|---|
| Spin Speed | 1400 rpm |
| Energy Efficiency Class | A+++ |
| Number of Programs | 16 |
| Spin-drying class | B |
| Weight | 70 kg |
| Color | White |
| Dimensions (H x W x D) | 85 x 60 cm |
| Loading type | Front-loading |
To Next Page
