EN 03
• Failure to comply with the above can compromise the safety of the
appliance and invalidate the guarantee.
• The appliance must not be installed behind a decorative door in order to
avoid overheating.
• lf the power cable is damaged, it should be substituted with a cable or
special bundle available from the manufacturer or by contacting the
customer service department. The type of power cable must be H05V2V2-F.
This operation should be carried out by a suitably qualified professional. The
earth conductor (yellow-green) must be approximately 10 mm longer than
the other conductors. For any repairs, refer only to the Customer Care
Department and request the use of original spare parts.
• When you place the shelf inside, make sure that the stop is directed
upwards and in the back of the cavity. The shelf must be inserted completely
into the cavity.
• The disconnection may be achieved by having the plug accessible or by
incorporating a switch in the fixed wiring in accordance with the wiring rules.
• A long power supply failure during an occurring cooking phase may cause a
malfunction of the monitor. ln this case contact customer service.
• Any excess of spilled material should be removed before cleaning.
• Do not use a steam cleaner for cleaning operations.
• Connect a plug to the supply cable that is able to bear the voltage, current
and load indicated on the tag and having the earth contact. The socket must
be suitable for the load indicated on the tag and must have ground contact
connected and in operation. The earth conductor is yellow-green in colour.
This operation should be carried out by a suitably qualified professional. ln
case of incompatibility between the socket and the appliance plug, ask a
qualified electrician to substitute the socket with another suitable type. The
plug and the socket must be conformed to the current norms of the
installation country. Connection to the power source can also be made by
placing an omnipolar breaker between the appliance and the power source
that can bear the maximum connected load and that is in line with current
legislation. The yellow-green earth cable should not be interrupted by the
breaker. The socket or omnipolar breaker used for the connection should be
easily accessible when the appliance is installed.
To Next Page
Loading...
