EN 5
compatibility between the socket and the appliance plug, ask a
qualied electrician to substitute the socket with another suita-
ble type. The plug and the socket must be conformed to the cur-
rent norms of the installation country. Connection to the power
source can also be made by placing an omnipolar breaker, with
contact separation compliant to the requirements for overvolt-
age category III, between the appliance and the power source
that can bear the maximum connected load and that is in line
with current legislation. The yellow-green earth cable should not
be interrupted by the breaker. The socket or omnipolar breaker
used for the connection should be easily accessible when the ap-
pliance is installed.
The disconnection may be achieved by having the plug accessi-
ble or by incorporating a switch in the xed wiring in accordance
with the wiring rules.
• lf the power cable is damaged, it should be substituted with a ca-
ble or special bundle available from the manufacturer or by con-
tacting the customer service department. The type of power
cable must be H05V2V2-F.
• This operation should be carried out by a suitably qualied pro-
fessional. The earth conductor (yellow-green) must be approxi-
mately 10 mm longer than the other conductors. For any repairs,
refer only to the Customer Care Department and request the
use of original spare parts.
• Failure to comply with the above can compromise the safety of
the appliance and invalidate the guarantee.
• Any excess of spilled material should be removed before clean-
ing.
• A long power supply failure during an occurring cooking phase
may cause a malfunction of the monitor. ln this case contact
customer service.
• The appliance must not be installed behind a decorative door in
order to avoid overheating.
• When you place the shelf inside, make sure that the stop is di-
To Next Page
Loading...
Need help?
General
