8. Reuse the disassembled top hinge, three screws and
hinge shaft sleeve.
A. Disassemble the axis of the hinge, swap over its po-
sition to the other side, then consolidate the axis
and screw it down.
B. Install the assembled top hinge. Screw it down and
fix it on target side
9. Install the top bar cover and a top cover buckle. Screw
down the four screws and cover them with caps. Finally
insert the top endcap cover slip
We recommend you have someone to assist you.
NOTE：
To take the door off it is necessary to tilt the Appliance backward.
You should rest the Appliance on something solid e.g.a chair just below the top panel
Do not lay the Appliance completely flat as this may damage the coolant system
MAINTENANCE
12
To Next Page
