CLEANING BEFORE USE
After you remove all of the packaging materials, especially the foam between the outside
condenser and cabinet clean the inside of your fridge freezer before using it.
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electrical shock. Before you
move your refrigerator-freezer into its final location, it is important to make sure you have
the proper electrical connection.
RECOMENDED EARTHING METHOD
AC220-240Volt /50Hz ,AC only 10 ampere fused and properly earthed electrical supply is re-
quired. It is recommended that a separate circuit serving only this appliance be provided. Use
a receptacle which cannot be turned off with a switch or pull chain. Do not use an extension
cord.
NOTE: Before performing any type of installation, disconnect the fridge freezer from the
electrical source. When you are finished, connect the fridge freezer to the electrical source
and reset the control to the desired setting.
INTRODUCTION
4
To Next Page
Loading...
