1. Remove the top bar cover fixed by four screws with
caps, then take off two top end cap covers lips and a
top cover buckle
2. Remove three screws of the top hinge, take the door
hinge as axis, turn over the top hinge in clockwise di-
rection, then the top hinge could be removed. Take off
the top door, and put it aside.
3. Remove middle hinge, screws, screw caps and plastic
inserting nails. Install them on the other side. Take off
the lower door and put it away.
4. The disassembly and installation of bottom parts
A. Disassemble lower hinge and screws. Then install
them on the other side and consolidate the lower
hinge.
Note: the product incline angle less 45°
B. Swap over the position of the adjustable foot to
the other side of the cabinet.
C. Swap over the position of the lower door block to
the other side, and install the screws and consoli-
date them.
5. Install the lower door
6. Tighten the screws of the middle hinge on the reversi-
ble side.
7. Install the top door and remove the existing top door
block. Install a new top door block (not the same one)
on the reversible side. Screw it down.
DOOR REVERSIBILITY
11
To Next Page
