Candy MECS34TX - Page 21

GB

）
indicator lighten . “℃” and “MIN” lighten. Default cooking time “10:00” lighten.
Press repeatedly to change function.
repeatedly, when " CLE " indicator lighten t means to enter Scale
t time " 20:00 " lighten, other icons disappear.
1 . Auto Scale Removal Function
R emoval function. “MIN” and defaul
i,
3
1
12. Patameter Adjustment in setting and cooking process
1) In the setting of the parameters, if the fault of the parameters is found, you can press
to return to a parameter set state. The corresponding parameters can be reset in the
same way as previous step.
2) In the cooking process, you can press to reset the cooking parameters.
The corresponding parameters can be reset in the same ways as previous step.
he T order of parameter adjustment is consistent with the setting state.
3) When finish the adjustment during cooking process, it will confirm automatically 3
seconds later if you don't press to confirm.
For
ste
a
Ru
n
best cleani
n
a
m microwa
v
n
steam pro
g
n
g results,
w
v
e oven. Fo
g
rams on m
y
we recomme
llow the ma
n
y
computer
t
end that you
ufacturer's
t
oday after 2
use deterge
instructions
0 hours, th
ent sodium
on the pac
e need for
d
citrate,which
kaging.
escaling.
were randomlyo
for desscaling
1) Power up the system, remove the water tank, inject 1000ml of fresh water into the
water tank, adding a pack of descaling agent.
2) Push the tank into the furnace where appropriate.
Note
prog
: the desca
ram must b
ling process
e started fro
s shall not b
om s .
e shut down. If the desccaling process shut down before the
entire end, the
6) Stay whole 1 minute after the program has finished, take out the water tank and pour
the water in the tank. Thoroughly clean the water tank.
tep 3
7) Replace the fresh water, repeat steps 3 to 6.
5) Press to start the program.
4) Press
It flickers 100,
In waiting state, press to enter steam function.
20
Downloaded from www.vandenborre.be