<Half Duplex>
Alternately sends and receives communication data. Select when the machine is connected to a
networking device using half duplex.
<Full Duplex>
Simultaneously sends and receives communication data. Use this setting for most environments.
3
<Ethernet Type> select the Ethernet type.
4
Select <Apply>.
5
Restart the machine.
● Turn OFF the machine, wait for at least 10 seconds, and turn it back ON.
LINKS
Changing the Maximum Transmission Unit(P. 63)
Setting a Wait Time for Connecting to a Network(P. 64)
Setting Up
62
To Next Page
Loading...
