2
Spread the slide guides apart.
● Slide the slide guides outward until they are slightly farther apart than the actual original width.
3
Fan the original stack and align the edges.
● Fan the original stack in small batches, and align the edges by lightly tapping the stack on a at surface a few
times.
4
Place the original(s) face up in the feeder.
● Make sure that the original stack does not exceed the load limit lines ( ).
● Do not load originals of various sizes at the same time.
● If originals are loaded so that they exceed the load limit line, scanning may stop or a paper jam may occur.
5
Align the slide guides against the edges of the original.
● Slide the slide guides inward until they are aligned securely against the edges of the original.
➠ The machine is ready to scan the original.
Basic Operations
137
To Next Page
Loading...
