2. Press â–² or â–¼ to select Roll Paper, and then press the OK button.
Note
• If any paper has been advanced that will not be used, a message is shown requesting you to remove it.
Press â–² or â–¼ to select "Yes", and then press the OK button. Remove the paper and go to the next
step.
3. Open the Roll Feed Unit Cover.
4.
Holding the Roll Holder flange (a), load the Roll Holder shaft into the guide grooves (b) on both sides of the Roll
Holder Slot. At this time, load the shaft so that the color of the Roll Holder shaft (c) matches the color of the guide
groove.
Caution
• Do not force the Roll Holder into the printer with the right and left ends reversed. This may damage
the printer and Roll Holder.
• Do not release the flanges until the holder is loaded in the Roll Holder Slot.
• Be careful not to pinch your fingers between the guide grooves (b) and the Roll Holder shaft (c) when
loading rolls.
Handling Paper
>
Handling rolls
>
iPF6300 Loading Rolls in the Printer
6
723
To Next Page
Loading...
Need help?
General