•
Head Cleaning A
Use this mode if printing is faint or contains foreign substances. This method of cleaning consumes the least
amount of ink.
It takes about three and a half minutes to complete.
•
Head Cleaning B
Use this mode if no ink is ejected at all, or if Head Cleaning A does not solve the problem.
It takes about four minutes to complete.
Caution
• Do not remove the Maintenance Cartridge or ink tanks during either Head Cleaning A or Head Cleaning B.
Note
• If printing does not improve after Head Cleaning B, try repeating Head Cleaning B once or twice. If this still does not
improve printing, the Printhead may have reached the end of its useful life. Contact your Canon dealer for assistance.
• Nozzles are periodically checked to ensure they are clear. Configure the settings on the Control Panel menu in Nozzle
Check. (See "Menu Settings.") →User's Guide
Perform cleaning as follows.
1
On the Tab Selection screen of the Control Panel, press â—€ or
â–¶ to select the Settings/Adj. tab ( ).
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press â–² or â–¼ to select Maintenance, and then press the OK button.
4
Press â–² or â–¼ to select Head Cleaning, and then press the OK button.
5
Press â–² or â–¼ to select Head Cleaning A or Head Cleaning B, and then press the OK button.
Head cleaning is now executed.
6
Print a test pattern to check the nozzles, and determine whether cleaning has cleared the nozzles. (See
"Checking for Nozzle Clogging.")
→User's Guide
Cleaning the Printhead
iPF765
Basic Guide
Maintenance and Consumables Cleaning the Printer
42
To Next Page
Loading...
