44 Dual Shot Mode
2 Touch the zoom controls to operate
the zoom.
Touch anywhere within the Q area to
zoom out or anywhere within the P area
to zoom in. Touch closer to the center for
a slow zoom ([Speed 1]); touch closer to
the e/d icons for faster zooms ([Speed 3]).
3Touch [a] to hide the zoom controls.
• Keep at least 1 m away from the subject. At full wide angle, you can
focus on a subject as close as 1 cm.
• In or mode, you can also set 7/8 8
[Zoom Speed] to one of three constant speeds (3 is the fastest, 1 the
slowest).
• When [Zoom Speed] is set to [I Variable]:
- When you use the P and Q buttons on the wireless controller, the
zoom speed will be constant at [J Speed 3].
- The zoom speed will be faster in record pause mode than when
actually recording, except when pre-recording (0 62) is activated.
• See Specifications (0 188) for notes about this function when the
recording program is set to [r Underwater] or [s Surface].
Quick Start Function
When you close the LCD panel with the camcorder on, the camcorder
enters the standby mode. In standby mode the camcorder consumes
only about 1/3 the power used when recording, saving energy when
you are using a battery pack. Additionally, when you open the LCD
panel, the camcorder is ready to start recording in approximately
1 second*, allowing you to record the subject right away.
* The actual time required varies depending on the shooting conditions.
1 With the camcorder on and in a recording mode, close the LCD
panel.
A beep will sound and the green ON/OFF (CHG) indicator will change
to orange to indicate the camcorder entered standby mode.
Operating modes:
To Next Page
Loading...
Need help?
General
Weight and Dimensions
