(26/58)
2-5. Notes on Transportation
This section describes the procedures for transporting the machine for returning after repair, etc.
1) In the service mode, press the ON button to finish the mode, and confirm that the paper lifting
plate of the rear tray is raised.
2) Keep the print head and ink tanks installed in the carriage. See Caution (a) below.
3) Turn off the machine to securely lock the carriage in the home position. (When the machine is
turned off, the carriage is automatically locked in place.) See Caution (b) below.
Caution: a. If the print head is removed from the machine and left alone by itself, ink (the
pigment-based black ink in particular) is likely to dry. For this reason, keep the print
head installed in the machine even during transportation.
b. Securely lock the carriage in the home position, to prevent the carriage from moving
and applying stress to the carriage flexible cable, or causing ink leakage, during
transportation.
Note: - If the print head must be removed from the machine and transported alone, attach the
protective cap (used when the packing was opened) to the print head (to protect the print
head face from damage due to shocks).
- If the packing material that fixed the carriage from the factory is still available, re-use it to fix
the carriage (to prevent the carriage unlocked during transportation).
To Next Page
Loading...
