To Next Page
R
Ronald YangSep 16, 2025
Why is the Rear Cover not attached properly on my Canon Printer?
- AAnthony DanielsSep 16, 2025
If the Rear Cover is not reattached properly after it has been removed, it can cause paper jams.
Why is the Rear Cover not attached properly on my Canon Printer?
If the Rear Cover is not reattached properly after it has been removed, it can cause paper jams.
What to do if the Canon Printer indicates that the ink has run out?
Replace the ink tank and close the Scanning Unit (Printer Cover) because the ink has run out. Printing under this condition may damage the machine. If you want to continue printing, release the function for detecting the remaining ink level by pressing and holding the Stop/Reset button for at least 5 seconds, and then release it. Be advised that Canon is not liable for any malfunction caused by continuing to print when the ink is out.
What to do if a Canon Printer error has occurred?
Turn off the Canon printer, and unplug the power cord from the power supply. After a while, plug the power cord back in, and then turn on the printer. If the same error occurs, contact a Canon service representative.
What to do if the Canon Printer ink absorber is almost full?
Press the OK button to cancel the error so you can continue printing. However, because printing is disabled once the ink absorber becomes completely full and until it is replaced, you are recommended to contact a Canon service representative as early as possible.
Why are there no photos in the Canon Printer memory card?
Make sure that there are no image data saved on the memory card that can be read by this machine. The machine may not recognize the file if the file name or the folder path contains certain characters; use only alphanumeric characters. Photo data edited or processed on a computer must be printed from the computer.
How to reinstall the Scanner driver (ScanGear) on a Canon Printer?
Follow the procedure described in your setup sheet to reinstall the MP Drivers.
Why is the original document not loaded correctly on my Canon Printer?
Check that the original is loaded correctly on the Platen Glass.
Why is my Canon Printer paper source selection inappropriate?
You cannot load paper other than A4, Letter, or B5-sized plain paper in the Front Tray.
Why is my Canon Printer not ready?
Check if the Power lamp is lit green. If the Power lamp is off, turn the Canon printer on. While the Power lamp is flashing green, the machine is initializing.
What to do if the Canon Printer scanner is not operating correctly?
Turn off the Canon printer, and unplug the power cord from the power supply. After a while, plug the power cord back in, and then turn on the machine. If the same error occurs, contact a Canon service representative.
General| Print Technology | Inkjet |
|---|---|
| Functions | Print, Copy, Scan |
| Print Resolution | 4800 x 1200 dpi |
| Scanner Type | Flatbed |
| Paper Capacity | 150 sheets |
| Connectivity | USB 2.0 |
| Print Speed (Black) | 30 ppm |
| Print Speed (Color) | 20 ppm |
| Scan Resolution | 2400 x 4800 dpi |
| Copy Speed (Black) | 30 cpm |
| Copy Speed (Color) | 20 cpm |
| Paper Sizes | A4, Letter, Legal, A5, B5, Envelopes |
| Ink Cartridges | Black, Cyan, Magenta, Yellow |
