Canon MP540 - Page 5

(5/58)
Cycles of
blinking of
Alarm and
Power LEDs
Error
Error
code
Conditions
Solution
(Check points and replacement items)
5 times ASF (cam)
sensor error
[5700] An error occurred in the
ASF cam sensor.
1) Cable connection
2) Part replacement:
- ASF unit
- PE sensor board unit
- Logic board
6 times Internal
temperature
error
[5400] The internal temperature is
not normal.
1) Cable connection
2) Part replacement:
- Carriage unit
- Logic board
- Print head
7 times Ink absorber full [5B00]
[5B01]
The ink absorber is
supposed to be full.
Message on the LCD:
Ink absorber full. Service
required.
Error codes:
5B00: Main ink absorber
is full (non-Japan).
5B01: Main ink absorber
is full (Japan).
1) Ink absorber condition
2) Part replacement:
- Ink absorber kit
3) Ink absorber counter value in the
EEPROM;
reset the ink absorber counter.
8 times Print head
temperature rise
error
[5200] The print head temperature
exceeded the specified
value.
1) Print head condition
2) Cable connection
3) Part replacement:
- Print head
- Logic board
9 times EEPROM error [6800]
[6801]
A problem occurred in
reading from or writing to
the EEPROM.
1) Part replacement:
- Logic board
10 times VH monitor error [B200] The internal temperature
exceeded the specified
value.
1) Part replacement:
- Print head and logic board
(Replace them at the same time.)
- Power supply unit
11 times Carriage lift
mechanism
error
[5110] The carriage did not move
up or down properly.
1) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
2) Part replacement:
- Switch system unit
- Carriage unit
12 times APP position
error
[6A80] An error occurred in the
APP motor.
14 times APP sensor
error
[6A90] An error occurred during
paper feeding or purging.
1) Foreign material or paper debris
around the purge drive system unit;
remove foreign material.
2) Foreign material or paper debris
around the ASF unit;
remove foreign material.
3) Cable connection
4) Part replacement:
- Purge drive system unit
- Logic board