Canon MX410 - Page 10

9
ENGLISH
6-A
5
4
2
3
1
F
J
H
I
G
K
6-B
7
1
2
M
L
N
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.•
When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
bit.
•
WEP
Select Authentication (J), then click OK (K).
Go to
.
Select Key ID (I).
Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
•
Select Key Length (G).
Select ASCII when the network key is 5 or 13 characters.
Select Hex when it is 10 or 26 characters (digits).
•
Select Key Format (H).
When using AirPort, select 1 in the screen.
Selecting other key numbers will disable the connection between the machine and
AirPort.
•
Enter the network key in WEP Key (F).
WPA/WPA2
Disable
When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
•
Disable
WPA/WPA2
Enter the network key in Passphrase (L).
Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
•
Select Dynamic Encryption Type (M), then click OK (N).
The Manual Setup screen returns. Click Connect.
After that, follow the on-screen instructions to proceed with settings.•
Go to .
When the access point is set to operate in IEEE802.11n and IEEE802.11g with TKIP
set as an encryption standard, communication is established using IEEE802.11g.
•
When the access point is set to operate in IEEE802.11n, TKIP cannot be used.
Change the encryption type to something other than TKIP or change the standard to
something other than IEEE802.11n, then configure wireless LAN settings again.
•