Check Printer Settings dialog box
is
displayed
Is
the machine connected to a network?
For details
on
how
to
check if the machine
is
connected
to
a network, refer to "Confirm Connection
Status"
on
page
32
in
the printed manual:
Getting
Started.
~I
For a wireless connection, make sure that you follow
Check
1,
2,
3,
4,
5 and 6
of
"Connection Checklist" on
page
11,
then click
Back
(A).
For a wired connection, make sure that you follow Check
1,
2,
3,
7 and 8
of
"Connection Checklist" on page
11,
then
click
Back
(A).
Proceed with the setup.
r--C_h_ec_k
I'B.'lh~tmt.m_
The message appears when the machine cannot be
lfifIilIi'I1m1lfif1il1i'11m1_
detected.
~
.
When obtaining an
IP
address automatically, make sure that the DHCP function
of
the
network device (router, access point, etc.) is active.
For details
on
how
to
check settings of
the
network device, refer
to
the manual supplied with the
network device or contact its manufacturer.
__
(*
Wireless connection only)
Is the privacy separator feature enabled on the access point?
• For details
on
how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
Activate the DHCP function
of
the network device, then click
Update
(A).
• For details on how to change settings
of
the network device, refer
to
the manual supplied with the
network device or contact its manufacturer.
Disable the privacy separator feature.
For details on how to change the settings
of
the access point, refer
to
the manual supplied with the
access point or contact its manufacturer.
Glossary
• IP address
filtering
A function
to
control traffic to/from specific
IP
addresses.
• DHCP
function
A function that automatically assigns required information (IP address, etc.) to computers connected to
the Internet.
•
Privacy
separator
feature
A function
to
prevent communication between multiple wireless devices connected
to
an access point.
If the machine is not connected to a network, perform setup again by following the
procedures
in
"Wireless Setup" on page 22 and onward
or
"Wired Setup" on page 29
and onward
in
the printed manual:
Getting
Started.
Is the IP filtering feature enabled on the network device (router, access point, etc.)?
For details on how to check settings
of
the network device, refer to the manual supplied with the
network device or contact its manufacturer.
Set the network device to accept the
IP
address
of
the machine.
For details on how
to
change settings of the network device, refer
to
the
manual supplied with the
network device or contact its manufacturer.
To
check the
IP
address
of
the machine, press the HOME button, then using the Easy-Scroll
Wheel and OK button, select
Settings>
Device
settings>
LAN
settings>
Confirm
LAN
settings>
Wireless
LAN
setting
list
or
Wired
LAN
setting
list, then check
IP
address.
5
To Next Page
Loading...
