Connection Checklist
Check
O
E!1!D
Before connecting the machine, are the computer and network device (router, access point, etc.) configured and can the computer connect to the network?
Configure the computer and network device.
• For the procedures, refer
to
the manuals supplied with the computer and network device, or contact their manufacturers.
O
Em!DI
Are the machine and network device (router, access point, etc.) turned on?
Turn
on
each device.
If the machine
is
already turned on, turn it off, then turn it back on.
0
....
Is
the firewall function of your security software active?
A message may appear
on
the computer monitor warning that Canon software is attempting to access the network.
If the warning message appears, set the security software to always allow access.
O
EmDII
When establishing a connection over a wireless LAN, is the Wi·Fi lamp (A) lit blue?
Press the HOME button, then using the Easy-Scroll Wheel and OK button, select
Settings>
Device
settings>
LAN
settings>
WLAN
active/inactive>
Wireless LAN
active
to enable wireless LAN.
• After enabling wireless LAN, perform setup again
by
following the procedures
in
"Wireless Setup" on page 22 and onward
in
the printed manual:
Getting
Started.
0
....
Are the access point and machine installed
in
an
open space where wireless communications are possible? Also,
is
there a microwave oven, refrigerator, etc. nearby?
Install them
in
an
open space with
as
few obstacles as possible.
To
prevent radio interference, leave some space between the installation location and a microwave oven, refrigerator, etc.
11
To Next Page
Loading...
