96
Appendices
Troubleshooting
Problem Cause(s) Solution(s)
• Slide the battery cover lock into the
locked position.
• Install the 2CR5 lithium battery with the
terminals oriented toward the back of
the chamber.
• Use a fully charged battery pack.
• Replace the battery.
• Use an approved AC power source.
• Use the specified battery pack or lithium
battery.
• Wipe the battery terminals with a clean,
dry cloth.
• Turn the Mode Dial to any one of the
(Auto), P (Program) or (Stitch Assist)
mode positions.
• Wait to press the shutter button until the
flash charges, the icon changes from
flashing to a steady light and the
indicator shines red.
Battery cover lock not in lock
position
2CR5 lithium battery is inserted
the wrong way
Insufficient battery power
(Display panel flashes [Lb])
Incorrect battery type
Poor contact between battery
and camera terminals
Mode Dial is set to the L (Lock)
position
Flash is charging
( icon flashes)
Camera will not operate
Camera will not shoot
To Next Page
Loading...
Need help?
General
