Instruction manual Di653 55
Please keep this instruction manual for future reference
PROBLEM POSSIBLE CAUSES WHAT TO DO
WHITE FILM ON
INSIDE SURFACE
Hard water minerals.
To clean the interior, use a damp sponge with dishwasher
detergent and wear rubber gloves. Never use any other
cleaner than dishwasher detergent otherwise, it may cause
foaming or suds.
THERE ARE RUST
STAINS ON CUTLERY
The affected items are not
corrosion resistant.
Avoid washing items that are not corrosion resistant in the
dishwasher.
A programme was not run
after dishwasher salt was
added. Traces of salt have
gotten into the wash cycle.
Always run a wash programme without any crockery after
adding salt. Do not select the Turbo function (if present),
after adding dishwasher salt.
The lid of the softer is loose. Check the softener lid is secure.
KNOCKING NOISE IN
THE DISHWASHER
A spray arm is knocking
against an item in a basket.
Interrupt the programme and rearrange the items which are
obstructing the spray arm.
RATTLING NOISE IN
THE DISHWASHER
Items of crockery are loose in
the dishwasher.
Interrupt the programme and rearrange the items of
crockery.
KNOCKING NOISE IN
THE WATER PIPES
This may be caused by on-site
installation or the cross-
section of the piping.
This has no influence on the dishwasher function. If in
doubt, contact a qualified plumber.
THE DISHES ARE NOT
CLEAN
The dishes were not
loaded correctly.
See “Loading the dishwasher baskets”pg 19
The programme was not
powerful enough.
Select a more intensive programme.
Not enough detergent was
dispensed.
Use more detergent, or change your detergent.
Items are blocking the
movement of the spray arms.
Rearrange the items so that the spray can rotate freely.
The filter combination is not
clean or is not correctly fitted
in the base of wash cabinet.
This may cause the spray arm
jets to get blocked.
Clean and/or fit the filter correctly. Clean the spray arm jets.
To Next Page
Loading...
