11Instruction manual PH500HPlease keep this instruction manual for future reference
CARE AND MAINTENANCE
Before any maintenance is carried out on the unit the electrical supply must be isolated.
Maintenance should be restricted to dust and lint removal around the unit. Do not tamper
with any electrical parts. A Caple approved engineer should be used for other maintenance
requirements.
TECHNICAL DATA
Test Pressure: 10 bar
Maximum working pressure:8 bar
Electrical supply: 220-240 V – 50 Hz.
Water connections: 15mm compression
Heat output: 3057-3979 Btu (0.9 - 1.17kW)
Maximum working pressure: 8bar (1Mpa)
Fuse rating: 3amp
To Next Page
Loading...