32 Instruction manual Ri7302 Please keep this instruction manual for future reference
REPLACING LED LIGHTING
LIGHT SOURCE ENERGY CLASS
This product contains a light source of energy efficiency class E.
The LED light must be replaced by an authorised engineer or similar only. For more
information, please contact Caple service - 0117 938 7420 or service@caple.co.uk
1. Carefully remove the 2 screws that secure the light.
2.Remove the LED light from its housing.
3.Disconnect the connector and change the LED light.
4.Implement the steps in reverse order.
5.After waiting 5 minutes, plug the unit.
,
Unplug the unit from the power supply before starting the process.
LIGHT SOURCE ENERGY CLASS
This product contains a light source of energy efficiency class F.
LED strip
Unplug the unit from the power supply before starting the process.
1. Press the hooks on the light cover (Fig. 1).
2. Open the light cover towards the arrow until the top hooks pull out from housing (Fig. 2).
3. Pull out the cover towards arrow remove it (Fig. 3).
4. Turn the light bulb counter clockwise and remove it (Fig. 4).
5. Change the present light bulb with a new one of not more than 15 W (Fig. 4).
6. Implement the steps in reverse order.
7. After waiting 5 minutes, plug the unit in.
1. Carefully remove the 2 screws that secure the light.
2.Remove the LED light from its housing.
3.Disconnect the connector and change the LED light.
4.Implement the steps in reverse order.
5.After waiting 5 minutes, plug the unit.
,
Unplug the unit from the power supply before starting the process.
LIGHT SOURCE ENERGY CLASS
This product contains a light source of energy efficiency class F.
LED strip
1. Press the hooks on the light cover (Fig. 1).
2. Open the light cover towards the arrow until the top hooks pull out from housing (Fig. 2).
3. Pull out the cover towards arrow remove it (Fig. 3).
4. Turn the light bulb counter clockwise and remove it (Fig. 4).
5. Change the present light bulb with a new one of not more than 15 W (Fig. 4).
6. Implement the steps in reverse order.
7. After waiting 5 minutes, plug the unit in.
,
Unplug the unit from the power supply before starting the process.
LIGHT SOURCE ENERGY CLASS
This product contains a light source of energy efficiency class F.
1
2
3
4
To Next Page
Loading...
