Appliances
120
Capron - 3141417 - 03/20 - EHG-0021-02EN
10
When turned on the refrigerator automatically selects the thermostat position
selected last. This position can be adjusted manually by using the arrow
keys (Fig. 123,2). The illuminated bars of the cooling level indicator
(Fig. 123,5) show the selected thermostat position. The refrigerating temper-
ature for the three types of energy is set with the arrow keys. It takes a few
hours till the refrigerator reaches its normal operating temperature. When
changing over the operating mode the thermostat setting will be maintained.
The refrigerating temperature is retained regardless of the type of energy
being used.
Never let gas escape unburned due to danger of explosion.
It is not permitted to operate the refrigerator with car gas.
Close the gas isolator tap "Refrigerator" when the refrigerator is oper-
ated electrically.
For gas operation, open the regulator tap on the gas bottle and the gas
isolator tap "Refrigerator".
Press and hold the On/Off button (Fig. 123,1) for 1 second. Button
(Fig. 123,1) lights up green. To save energy, after approximately 10 sec-
onds the display is dimmed.
Press and hold the confirmation button (Fig. 123,3) for about 2 seconds.
The symbols for the operating modes (Fig. 123,4) are flashing.
Press the arrow keys (Fig. 123,2) to change the operating mode.
For gas operation, select the operating mode Gas using the arrow keys
(Fig. 123,2). Gas supply is open. Ignition will take place automatically. A
ticking sound can be heard until ignition has been completed success-
fully.
Press confirmation button (Fig. 123,3).
Press confirmation button (Fig. 123,3) again. The current cooling level is
shown by the illuminated bars (Fig. 123,5).
To change the setting, press the arrow keys (Fig. 123,2) until the de-
sired setting is displayed.
Press and hold the On/Off button (Fig. 123,1) for about 2 seconds. All
lights go out. Refrigerator is switched off.
In case of gas operation, close the gas isolator tap "Refrigerator" and
the regulator tap on the gas bottle.
When operated with 12 V, the refrigerator draws power only from the starter
battery of the vehicle. The starter battery only supplies the refrigerator with
12 V when the vehicle engine is running. If the vehicle engine is switched
off, the cooling no longer operates. However the refrigerator continues to
operate via the transformer/rectifier with a control voltage from the living
room area battery. For this reason, change over to gas operation during pro-
longed driving breaks.
Further information can be obtained from the separate instruction man-
ual "Refrigerator".
Refrigerating temperature
control
Switching on:
Switching off:
To Next Page
Loading...