4
Operation Modes area imager
Capture Area Imager supports various operation modes, including trigger,
presentation, alternative, level, force, toggle, diagnostic, low power and
multiple read modes. The details of each operation mode are listed below for
reference.
When trigger mode is selected, the scanner goes into standby state after
scanning the bar code. You must press the trigger switch to turn on the
scanner’s light source before scanning the bar code.
When presentation mode is selected, the scanner is preset to turn on the
background lighting to detect the bar codes. Once the scanner detects an
image similar to a bar code, it will try to decode the bar code immediately.
All manuals and user guides at all-guides.com
To Next Page
Loading...