50
Smart TV CB24iTV, CB28iTV & CB32iTV | 49892, 49891 & 49890UK
Network
Select the desired network and connect the device to your network to access the SMART TV
content after the initial installation. If your W-Lan is password protected, it will be needed to
connect the devices.
Note:
• If you do not select a network, you can skip the network setting using the [▲u ] button.
• The network configuration can also be set later.
1. Use the [▲▲ ▼▲] buttons to navigate in the menu and select the desired network.
2. Confirm the network with the [OK] key.
3. Enter your network password via the menu bar and go to „Done“.
4. Press the [ ▼▲] key twice to access the „Connect“ menu item.
5. Press the [OK] key to confirm the entry.
6. Press the [▲u ] key to go to the next menu item „Location“.
7. Use the [▲t ] key to go to the last menu item „Time zone“.
Place
Select the location of your TV set.
1. Press the [▲▲ ▼▲] buttons to navigate in the menu.
2. Use the [OK] key to select the desired menu item.
3. Use the [▲u ] key to go to the next menu item „Welcome“.
4. Use the [▲t ] key to go to the last menu item „Network“.
Welcome
Select whether you enter the Smart TV area or the Tuner setting after setting.
1. Use the [▲▲ ▼▲] buttons to navigate in the menu, and then select Site.
2. Use the [OK] key to select the desired menu item.
3. Press the [▲u ] button to go to the next menu item „Start TV“ or „Start Launcher“.
4. Use the [▲t ] key to go to the last menu item „Location“.
• Go to „TV Mode“ to access the DVB-C, DVB-T / T2HD or satellite range.
• Go to „Smart TV Mode“ to access the Smart TV content.
Smart TV mode
Complete the initial installation and enter the Smart TV interface.
1. Select the menu item with the [▲▲ ▼▲] buttons.
2. Press the [OK] key to confirm the entry.
3. Press the [▲u ] key to complete the initial installation and enter „Smart TV Mode“.
To Next Page
Loading...
