Part number 3E1089 R3 7
March 2003
Dip Switch Setting Meaning
DS1 ON Controller will accept WWW connections.
OFF Controller will reject WWW connections.
DS2 ON Initialise. On startup configuration and the IP
address is deleted.
OFF Normal Startup - Configuration will be retained.
DS3 OFF Unused
DS4 ON When DS2 is on this will cause the Controller to be
configured with PPP (dial-up) as the default network
interface.
OFF When DS2 is on this will cause the Controller to be
configured with Ethernet as the default network
interface (default).
DS5 ON On startup, the main code does not run. Instead, the local
config program attempts to establish connection via serial
COM port.
OFF On startup, the main application (e.g. B201b4.exe) is
run.
DS6 OFF Unused
DS7 OFF Unused
DS8 OFF Unused
Dip Switch Settings
The following table shows the Dip Switch Settings. The Settings in bold specify the default
startup configuration.
Ethernet connection LEDs
Component Function LED will light when...........
D9 LAN Activity LED During normal operation, this active-low output
goes low for 6ms whenever there is a receive
packet, a transmit packet, or a collision. During
Hardware Standby mode, this output is driven
low when the receiver detects network activity.
D10 Link Good LED This active-low output is low when the CS8900A
detects the presence of valid link pulses.
To Next Page
Loading...