Cardo Systems Scala Rider PACKTALK - 5.2 a 1+8 INTERCOM TOGGLING; Buddy Name Configuration; Pairing 1+8 Buddies; Calling 1+8 Buddies

5.2a “1+8” INTERCOM TOGGLING
with PACKTALK, G9 / G9X and cardo SHO1
Pair with up to 8 other devices (“1+8” Buddies) and connect with them one at a time by
saying their name.
CONFIGURE YOUR BUDDY NAME
Before using “1+8” Intercom, you should assign yourself a Buddy name, so that other
paired Buddies can call you by this name. Visit the Cardo Community to congure your
Buddy Name (see Section 3).
Until you congure a Buddy name, your unit will be known as “PACKTALK”.
If you change your Buddy name, you must pair again with your “1+8” Buddies for their
devices to receive the new name.
Hear Your
Buddy Name
In Standby, press
Z
and v simultaneously for 2 seconds. You will hear your
Buddy name through the speakers.
Check Your
Buddy List
Check via the Cardo SmartSet and Cardo Community. You can also hear your
Buddy List through the speakers: In Standby, press
Z
for 2 seconds
PAIRING “1+8” BUDDIES
There are three ways to pair with “1+8” Buddies:
OPTION 1: Via the Cardo Community® (see 3.1)
g OPTION 2: Via the Cardo SmartSet App (see 3.2)
☛
OPTION 3: Manual “1+8” Pairing
1. In Standby, press
Z
for 5 seconds to enter “1+8” Pairing mode.
2. Enter “1+8” Pairing mode on the second unit.
3. A purple LED for 2 seconds indicates pairing was successful.
If your scala rider already has a full list of 8 paired “1+8” Buddies, pairing another buddy will
replace the buddy that you have not spoken to for the longest time.
CALLING “1+8” BUDDIES
There are three ways to start an intercom call with “1+8” buddies.
OPTION 1: Voice Command VOX
Say any word loudly into the microphone. When you hear the Voice Command tone,
say the name of a ”1+8” Buddy i.e. “John Smith”. VOX Operation settings must be set
to “Voice Command” (see section 3).
☛
OPTION 2: Manual Mode
SAY THE NAME CHOOSE THE NAME (from your Buddy List):
Tap
Z
and say
the Buddy name
In Standby, press
Z
for 2 seconds to hear your Buddy List.
When you hear the name of the Buddy you wish to call, tap
Z
or say any word loudly into the microphone.
To cancel Buddy List playback: Press
Z
for 2 seconds.
g OPTION 3: Via the Cardo SmartSet App (see 3.2)
12 |