Cardo Systems scalarider q1 Quick Guide

7
| INTERCOM
Note: TeamSet units are already factory paired!
Pairing
Your Q1 unit has an Intercom channel for communication between rider
and passenger.
In Standby, press “IC” for 5 sec. on both units until LEDs begin ashing
rapidly. After a few seconds, the LED will ash RED for 2 seconds,
indicating that the unit is paired and ready to use.
Calling
Start Intercom call Tap “IC”
End Intercom call Tap “IC”
Voice Connect (VOX)
Speak any word loudly into the microphone to activate the VOX. An
intercom call will start automatically.
8
| CLICK TO LINK® “CTL” CALLS
Send a “CTL” call request
(search lasts up to
10 seconds)
In standby, press “MM” for 2 seconds
End a “CTL” call /
Cancel “CTL” request
Tap “IC”
Accept a “CTL” call
When hearing the CTL ringtone:
Tap “IC” or say any word loudly to answer
by VOX
Reject a “CTL” call
Remain silent until the CTL ringtone stops or
press “IC” for 2 seconds
Enable/Disable “CTL”
(Enabled by default)
Via the Voice Menu or the Cardo Community
9
| RADIO STATION TUNING
Seek up/down and Save
Choose a preset by tapping “MM”
Press “V+” or “V-” for 2 seconds
Tap “MM” within 20 seconds to save to
current preset
Scan: Automatically
scans up for a station
With Radio ON, press “V+” for 5 seconds
To stop search, tap “V+” or “V-”
Tap “MM” within 20 seconds to save to
current preset
Automatic Radio Tuning:
Save 6 Temporary
Stations
With Radio ON, press “V-” for 5 seconds
Enable / Disable RDS
With Radio ON, press “V+” and “V-”
simultaneously for 2 seconds
MAN01001 – for Q1-Q1 TeamSet_003A2
10
| CARDO COMMUNITY® PLATFORM
Visit http://community.cardosystems.com to:
• Register your device for warranty and technical support
• Download and install the latest software upgrades
• Customize settings
11
| TROUBLESHOOTING
Reboot
If your scala rider stops responding reset it by
turning it o and then on again (press “IC” for
2 seconds).
Reset Pairing
(Deletes all
paired devices)
1. In Standby, press “V+” for 5 seconds until LED
ashes RED/BLUE.
2. Press “MM” for 2 seconds until LED ashes
5 times in PURPLE and unit turns o.
The contents of this Quick Guide, including all text, illustrations and drawings are
the exclusive intellectual property of Cardo Systems, Inc. (the “Company”) and are
protected by copyright laws. Any partial or total reproduction, translation and or
dissemination, without the prior written authorization by the Company are strictly
prohibited. Any rights not expressly granted herein are reserved.
Intercom
Button
(“IC”)
Music / Mobile
Button (“MM”)
Volume Up
(“V+”)
Volume Down
(“V-”)

Cardo Systems scalarider q1 Specifications

General

Brand	Cardo Systems
Model	scalarider q1
Category	Motorcycle Accessories
Language	English