User Manual User Manual
7
8
Set opening stadus:
Opening stadus
1.Chinese
2.English
Use any one of the administrator fingerprint/password or card
to open the door. Press the "2" and "8" keys when the keyboard
lighton.
If the battery is out of power and the door lock does not work
properly, you can connect the power bank by Micro-USB 5V .
into charging line connect the into the emergenly power
interface under the outer panel and unlock it in the nomal
way.
Relieve opening stadus:
Use any one of the administrator fingerprint/password or card
to open the door and relieve it.
1. Remove the battery cover.
2. Press and hold the· reset button , and the voice prompt
“Initialization finished”indicating that the lock has been initialized
successfully.
If you accidentally forget the password, you can remove the back panel battery cover
and initialize the system with power on.
Steps as follows：
Note
设 时间
Note
Emergency power supply method
Reset
Reset button
Emergency power interface
(in the button)
When the battery power is lower than 4.6V, after the system successfully unlocks the
lock each time, the system will have a voice prompt: "low power, please replace the
battery". At this time, please timely replace the battery.(please do not mix old and
new batteries with different models.)
After the reset, all previously setted fingerprints/passwords
cards will be cleared.
To Next Page
Loading...
General