CareFusion PrinterNOx - Page 18


16
Syringe
adapter
1 5
5
1 0
2 0
Should the water trap fill during the course of the measurement, it
will overflow into the integral hydrophobic PTFE filter, cause an
obstruction, and the following message will be displayed:

GasLineOccluded
orwatertrapfull
Pleaseclearblockage
oremptywatertrap
andfilter.

Unscrew the two retaining screws, and remove the water trap from
the PrinterNOx.
Empty the accumulated water into a suitable container by
connecting a syringe (20ml minimum size) with the adapter supplied
and pushing air through the assembly as shown below.


