10
4G connectivity
Initial connection setup for boss micro
Part Number: BMBST00DP0, boss micro 4G with WIFI
Accessory: BMBSTEGA00, 3m External 4G Antenna
General Note:
− SIM card is not provided, standard size data SIM required
− Before installation review local 3G/4G reception
− If mounted inside an enclosure use external 4G antenna for signal extension
− External antenna need to be protected against rain, sunlight
− To avoid interference to with the WIFI antenna it’s recommended to use external 4G
antenna. If both external antenna’s are mounted, they must be mounted at least 30cm
apart from each other
Attention: Do not invert the WIFI antenna with the 4G antenna!
The boss micro with the above part number is a compact DIN module that’s capable of
direct push notification over 3G or 4G mobile network. With that option it’s possible to send
alarm notifications or temperature reports without any additional connection. The push
notifications can include Email, SMS and telegram messages.
Please ensure the boss micro is powered off and disconnected from power supply when
inserting the SIM card.
Inserting the SIM card:
The SIM card connector will be behind the front cover. Please remove the front cover as
illustrated below. Open the SIM card connector by using a small screwdriver and unlock
the lid of the SIM connector by gently sliding it downwards.
The standard size SIM card slides into the lid of the SIM connector.
Close the lid with the insert SIM card and lock the connector by gently pushing it upwards
into the locked position.
Close the front cover and reconnect the boss micro to the power supply.
SIM connector
To Next Page
Loading...
