Need help?Do you have a question about the Carel IROPZKEY00 and is the answer not in the manual?
General| Brand | Carel |
|---|---|
| Model | IROPZKEY00 |
| Category | Controller |
| Language | English |
Details the operating modes, special modes, and available accessories for the controllers.
Explains how to use the programming key to transfer settings.
Details how to set frequent (P) and configuration (C/d) parameters.
Sets serial address, enables interfaces, and configures start-up delays.
Parameters for setting probe type, calibration, and filters.
Describes direct, reverse, PWM, and alarm operating modes.
Enables custom operating logic and special parameters via c33.
Defines parameters for individual output configuration (dependence, type, activation, etc.).
Compares ON/OFF control with PID control for systems.
Sets the control type (ON/OFF or PID) using parameter c5.
PID parameters for integral and derivative time settings (c62,c63).
Procedure for automatically tuning PID parameters using c64.
Details Auto-Tuning procedure during system setup.
Control based on the difference between two probes (c19=1).
Modifies set point based on outside temp. in cooling (c19=2).
Modifies set point based on outside temp. in heating (c19=3).
Lists parameters for set points, operating modes, and control differentials.
Lists parameters for output control, alarms, and digital inputs.
Lists parameters for software revisions, timing, and alarms.
Table of alarm codes, messages, and control actions.
To Next Page
