26
¦ >ABNORMAL WORKING< ¦
+--------------------+
CONTA1 (MAINTENANCE BRANCH)
+--------------------+ First mask of the maintenance branch you reach
¦Time Counter AL¦ by pressing the “Maintenance” button. This is the
mask
¦Fan 00000 ¦ for the visualisation of fan/2 compressors working
¦Compressor 1 00000 ¦ hours. By pressing the
and the buttons
¦Compressor 2 00000 ¦ you can move upwards and downwards the loop.
+--------------------+
CONTA2 (MAINTENANCE BRANCH)
+--------------------+ Visualisation of humidifier working hours.
¦Time Counter AL¦
¦ ¦
¦Humidifier 00000 ¦
¦ ¦
+--------------------+
OREVEN (MAINTENANCE BRANCH)
+--------------------+ Mask for Fan Hours Threshold programming and for
¦-- Fan AL¦ already calculated hours clearing. For the clearing
¦Working Hours: 00000¦ function it is necessary to keep pressed for a
¦Hours Thr. : 00000¦ couple of seconds the
or the button on the
¦Reset No ¦ No word. The same is for the following masks.
+--------------------+
ORECOMP1 (MAINTENANCE BRANCH)
+--------------------+ Mask for Compressor 1 Hours Threshold programming
¦-- Compressor 1 AL¦ and for already calculated hours clearing.
¦Working Hours: 00000¦
¦Hours Thr. : 00000¦
¦Reset No ¦
+--------------------+
ORECOMP2 (MAINTENANCE BRANCH)
+--------------------+ Mask for Compressor 2 Hours Threshold programming
¦-- Compressor 2 AL¦ and for already calculated hours clearing.
¦Working Hours: 00000¦
¦Hours Thr. : 00000¦
¦Reset No ¦
+--------------------+
OREUMID (MAINTENANCE BRANCH)
+--------------------+ Mask for Humidifier Hours Threshold programming
¦-- Humidifier AL¦ and for already calculated hours clearing.
¦Working Hours: 00000¦
¦Hours Thr. : 00000¦
¦Reset No ¦
+--------------------+
PRINT1 (PRINTER BRANCH)
+--------------------+ First mask of the printer branch you reach by
¦ PRINTER AL¦ pressing the "Printer" button. By pressing the
¦ ¦ and the buttons you can move within the loop.
¦Immediate Print ¦ In this mask the immediate print of probes and
¦Enabled? No¦ alarms reading can be selected.
+--------------------+