Carel pRack PR100

Integrated Control Solutions & Energy Savings
NO POWER
& SIGNAL
CABLES
TOGETHER
READ CAREFULLY IN THE TEXT!
pRack PR100
Quick guide
compressor rack controller
LEIA E CONSERVE
ESTAS INSTRUÇÕES
READ AND SAVE
THESE INSTRUCTIONS

Carel pRack PR100 Specifications

General

Brand	Carel
Model	pRack PR100
Category	Controller
Language	English

Summary

IMPORTANT

General Safety and Handling Precautions

Crucial warnings regarding product use, installation, and handling.

Waste Electrical and Electronic Equipment (WEEE) Disposal

Information on correct WEEE disposal according to EU directive.

Warranty and Approval Information

Details on material warranty and ISO 9001 quality certification.

START UP

1.1 Starting the first time

Preliminary operations for configuring the installation after proper installation.

1.2 Pre-configurations

Choosing from thirteen pre-loaded configurations in the pRack software.

1.3 Wizard

Guided configuration process by answering screen-by-screen questions.

1.4 Example of configuring a system with 2 suction and condenser lines using the Wizard

Example of configuring a system with 2 suction and 2 condenser lines using the Wizard.

1.5 Advanced configuration

Establishing PLAN structure for correct system operation for expert users.

PRE-CONFIGURATION

2.1 Pre-configuration 1: RS2

Configuration for 2 reciprocating/scroll compressors and 2 fans.

2.2 Pre-configuration 2: RS3

Configuration for 3 reciprocating/scroll compressors and 3 fans.

2.3 Pre-configuration 3: RS3 p

Configuration for 3 reciprocating compressors with unloader and 1 fan stage.

2.4 Pre-configuration 4: RS3 i

Configuration for 3 reciprocating compressors, first with inverter, and 1 fan stage.

2.5 Pre-configuration 5: RS4

Configuration for 4 reciprocating/scroll compressors and 4 fans.

2.6 Pre-configurazione 6: RS4 i

Configuration for 4 reciprocating/scroll compressors, first with inverter, and 1 fan stage.

2.7 Pre-configuration 7: SL3 d

Configuration for 3 scroll compressors, first Digital Scroll, and 2 fans.

2.8 Pre-configuration 8: SL5 d

Configuration for 5 scroll compressors, first Digital Scroll, and 1 fan stage.

2.9 Pre-configuration 9: SW1

Configuration for 1 screw compressor with continuous modulation and 2 fan stages.

2.10 Pre-configuration 10: SW2

Configuration for 2 screw compressors with continuous modulation and 1 fan stage.

2.11 Pre-configuration 11: d-RS2

Configuration for double suction line with 2 reciprocating/scroll compressors per line and 2 fans.

2.12 Pre-configuration 12: d-RS3

Configuration for 2 lines on the same board, 3 compressors/line, 3 fans/line.

2.13 Pre-configuration 13: d-RS4

Configuration for 2 lines in separated boards, 4 compressors/line, first with inverter.