15” DRUM MACHINE OPERATION
36
TURN AUTO-FEED PLUS ON
(CONTROLS MAY VARY DEPENDING ON AUTOFEED
OPTION)
• The Auto-Feed Plus® monitors the
engine RPM and controls the feed
system based on this information. The
Auto-Feed® is calibrated when installed
in the chipper with a high and low RPM
setting for the feed wheels to operate.
When the engine RPM is low and the
Auto-Feed® is on, the hydraulics will
not work. If large diameter wood is
being chipped and the engine RPM
drops below the Auto-Feed® Low
setting, the Auto-Feed® will stop the
feed wheels. After the engine RPM is
high enough to handle the force required
to chip this material without causing the
engine to lug down, the Auto-Feed®
restarts the feed wheels.
• The Auto-Feed Plus® control is
calibrated to automatically come on
when the chipper is started. If for some
reason you need to turn on the Auto-
Feed Plus® control, press and hold the
right button down for 4 seconds and
release. (See Auto-Feed Plus® manual
included in this chipper manual.)
AUTO-FEED® ONAUTO-FEED® OFF
To Next Page
